Jump-starting a car: the last black clamp goes on bare metal, not on the dead battery
A dead 12-volt battery is a common cold-weather and holiday-trip problem, and the order you clip jumper cables on matters. Every source checked here gives the same sequence: red to the dead battery's positive (+) post, red to the booster's positive, black to the booster's negative (-), then the last black clamp to bare, unpainted metal on the dead car's engine, away from the battery, not to the dead battery's own negative post. [S1] [S2] [S3] [S5]
Our take: open your owner's manual first, check the dead battery isn't frozen or bulging, keep the two cars from touching, then connect red, red, black, and finish with the last black clamp on bare metal well away from the battery. Start the booster car, then the dead one, and take the cables off in reverse order. That's our reading of the sources, not professional advice, and your owner's manual overrules it. If you're unsure or the battery looks damaged, call roadside assistance or a tow service. [S2] [S3] [S4] [S5]
The jump-start order, step by step
| Stage | What to do | Why, per the sources |
|---|---|---|
| Before you start | Owner's manual open, both cars off and not touching, 12-volt systems only, battery not frozen or bulging | Frozen or low-electrolyte batteries can rupture or explode; manuals differ by vehicle |
| 1. Red clamp | Dead battery's positive (+) terminal | The first connection is always positive on the dead battery |
| 2. Red clamp | Booster battery's positive (+) terminal | Joins the two positives |
| 3. Black clamp | Booster battery's negative (-) terminal | Joins the working negative |
| 4. Black clamp, last | Bare, unpainted metal on the dead car's engine, away from the battery | Keeps the final spark away from the battery's hydrogen gas |
| 5. Start | Booster car first, then the dead car | Gives the dead battery a few minutes of help before cranking |
| 6. Remove | Reverse order: last black first, last red last | Clamps and cables must never touch each other or either car |
Red to dead. Red to good. Black to good. Black to bare metal.
Why the order matters
- Same order everywhere. AAA Oregon/Idaho, AAA's battery brochure, a 2027 Kia owner's manual, a Ford hybrid owner's manual and CAA-Quebec all connect positive on the dead battery first, positive on the booster second, negative on the booster third, and a ground point on the dead car last. [S1] [S2] [S3] [S4] [S5]
- The danger is the last spark. Batteries give off hydrogen gas, which can explode if it meets a flame or spark. The last clamp is the one that can spark, so the sources put it away from the battery. Connecting the last black clamp to the dead battery's negative terminal is the mistake they warn about most, with AAA Oregon/Idaho and CAA-Quebec naming explosion risk and AAA saying it risks damage from sparks. [S1] [S2] [S3] [S5]
- Kia gives a second reason. Its manual says connecting the booster's negative to the discharged battery's negative can make the discharged battery overheat and crack or degrade. [S3]
- How far is "away"? CAA-Quebec says at least 30 centimeters (about a foot) from the battery and to avoid body panels; AAA says as far from the battery as possible; Ford says away from the battery and the fuel injection system. The Kia manual says a solid, stationary metal point away from the battery. [S2] [S3] [S4] [S5]
Before you start
- Read your manual. AAA calls its steps generic and says to check the owner's manual for vehicle-specific instructions; CAA-Quebec says to make sure the steps match the manual. [S2] [S5]
- Check the dead battery. Don't jump a battery that is frozen, swollen or has a wavy or bulging case. AAA says in low temperatures look for a bulging case or ice in the cells, and never jump-start a battery that is frozen or low on electrolyte, because it may rupture or explode. Kia gives the same warning. [S2] [S3] [S5]
- Cars and systems. Park so the cars don't touch. Use a 12-volt system only: Kia and Ford both say not to use 24 volts, and Kia says that can wreck the starter and electrical parts. Turn off the ignition, headlights, radio and other loads in both cars, and set the parking brake. CAA-Quebec says Park for an automatic and Neutral for a manual. [S1] [S3] [S4] [S5]
- Keyless cars. AAA says that if either car has keyless ignition, keep the smart fob at least 10 feet away from the vehicle before connecting cables. That brochure dates from 2008, so check your manual too. [S2]
- Cables and safety gear. Use cables in good condition with no frayed wires or exposed metal. Ford says use only adequately sized cables with insulated clamps. Wear eye protection and gloves, take off jewelry, keep flames and cigarettes away, and don't lean over the battery. [S1] [S2] [S4] [S3]
Connecting the cables
- Red clamp one. Dead battery's positive (+) terminal. [S1] [S2] [S3] [S5]
- Red clamp two. Booster battery's positive (+) terminal. [S1] [S2] [S3] [S5]
- Black clamp one. Booster battery's negative (-) terminal. [S1] [S2] [S3] [S5]
- Black clamp two, last. Bare, unpainted metal on the dead car's engine, away from the battery. The sources name the engine block, an accessory or alternator bracket, the engine lifting bracket or a marked ground point. Never the dead battery's negative terminal. [S1] [S2] [S3] [S4] [S5]
- Keep the clamps apart. Never let the red and black clamps touch each other, and don't let the cables touch anything except the right terminal or ground. [S1] [S3]
Starting and running
- Booster first. Start the booster car and let it run for a few minutes. Kia says run it at 2,000 rpm for several minutes; Ford says keep it between 2,000 and 3,000 rpm. [S1] [S3] [S4] [S5]
- Then the dead car. Try to start it. AAA Oregon/Idaho says that if it doesn't start right away, let the booster run a few more minutes and try again. CAA-Quebec says not to crank the starter for more than 15 seconds at a time. [S1] [S5]
- Once it runs. The sources disagree on how long to keep the cables on, from "disconnect once it starts" to five minutes. See the box below, and follow your manual. [S3] [S4] [S5]
- Then drive. AAA Oregon/Idaho says let the car run at least 30 minutes, or take a short drive, so the alternator can recharge the battery. [S1]
Taking the cables off
- Reverse order. Last black clamp first (from the engine metal), then the black clamp on the booster, then the red on the booster, and the red on the formerly dead battery last. [S1] [S3] [S4]
- Don't rush it. CAA-Quebec lists disconnecting too quickly as a cause of power surges, and says leave the cables on for 5 minutes after the car starts. [S5]
- Keep them apart. Don't let the loose clamps touch each other or either car as you remove them. [S1] [S3]
Hybrids, jump packs and other cases
- Hybrids. Ford's manual for its hybrids says the 12-volt battery has two prongs under the hood and is jumped the same way as a conventional vehicle: positive first, with the last negative connection on a ground point or exposed engine metal, not other parts of the vehicle. Afterward it says to let the car sit in Ready to Drive mode for several minutes. Other makes and electric vehicles can differ, so use your own manual. [S4]
- Jump packs. Ford says to follow the pack maker's instructions. CAA-Quebec says the same connection method applies with a portable booster. Check the pack's manual first. [S4] [S5]
- Automatics. Ford says not to push-start an automatic transmission vehicle, which may damage the transmission. [S4]
- Don't disconnect the battery. Ford says not to disconnect the disabled vehicle's battery, which could damage its electrical system. [S4]
When to stop, and what to do afterward
- When to stop. Kia says if you are in doubt, have a technician or towing service do it. CAA-Quebec says if a battery is fully dead, the safest choice is roadside assistance. AAA Oregon/Idaho says to seek professional help if you are uncertain. [S1] [S3] [S5]
- Weak-battery signs. AAA lists slow cranking, dim headlamps, particularly at idle, and the battery or charging warning lamp. It suggests having the battery, starter and charging system tested yearly, and says most batteries last three to five years (2008 brochure). [S2]
- If it keeps happening. Kia says to have the vehicle checked if it isn't obvious why the battery discharged. [S3]
- Related NBB guides. For a stuck-in-the-cold kit see the winter car kit guide, and for a pre-trip check see the Thanksgiving drive check.
Where the sources line up
All five sources agree on the connection order and on keeping the last black clamp off the dead battery. They differ on what happens after the car starts. AAA Oregon/Idaho says let it run at least 30 minutes; Ford says run both engines three more minutes before removing the cables; CAA-Quebec says leave the cables on 5 minutes; Kia only says to disconnect once the car starts; the 2008 AAA brochure says high idle for 30 seconds or more. They also split on headlights: the 2008 AAA brochure says turn on the headlights and heater blower before removing the cables, while Ford says not to switch headlamps on when disconnecting, because peak voltage could blow the bulbs. The final ground point is called the engine block, an accessory or alternator bracket, the engine lifting bracket or an exposed engine metal part. Only the 2008 AAA brochure mentions keyless fobs. This guide states each as the source does and defers to your owner's manual. The CAA-Quebec page was updated December 17, 2025; the AAA Oregon/Idaho, Kia and Ford pages show no date; the AAA brochure is from 2008. All five were read November 12, 2026.
Jump-start helper
Pick your situation. The answer puts what the sources say in one place. It's general guidance, not professional advice. [S1] [S2] [S3] [S4] [S5]
Choose an option to start.
Jump-start checklist
Before you clip anything
Quick answers
Why not the dead battery's negative terminal?
The last connection can spark, and batteries give off hydrogen gas. AAA Oregon/Idaho and CAA-Quebec name an explosion risk, and Kia says it can overheat and crack the discharged battery. [S1] [S3] [S5]
Can the last clamp go on any metal?
No. The sources say bare, unpainted, solid metal on the dead car's engine, away from the battery. Ford says away from the fuel injection system and to use nothing else on the vehicle; CAA-Quebec says avoid body panels. [S1] [S4] [S5]
Can I push-start an automatic?
Ford says not to, because it may damage the transmission. [S4]
How long should I run the engine afterward?
The sources differ: Ford says three more minutes with both engines before disconnecting, CAA-Quebec says 5 minutes with the cables on, and AAA Oregon/Idaho says at least 30 minutes or a short drive afterward. Check your manual. [S1] [S4] [S5]
Is anything ranked here?
No. This guide explains published auto club and manufacturer guidance. It doesn't rank or endorse any cable, jump pack, battery or brand, and nothing was tested for it. Related NBB guides are linked only for deeper reading.
Sources
Auto club and manufacturer pages checked November 12, 2026. Recommendations here are our editorial reading of those pages; no hands-on results are claimed.
- S1 · AAA Oregon/Idaho: Jump-Starting Your Car Battery: A Safe and Easy Guide (Live page read November 12, 2026 (no page date shown))
- S2 · AAA: Make Sense of Car Care, Batteries (brochure) (Copyright 2008, printed 8/08 (shown in the PDF; uploaded 2012))
- S3 · Kia owner's manual (model code LQ2, 2027 model year): Jump starting (Live page read November 12, 2026 (2027 model-year manual, no page date shown))
- S4 · Ford owner manual: Jump Starting the Vehicle (Hybrid and Plug-In Hybrid Electric Vehicle) (Live page read November 12, 2026 (no page date shown))
- S5 · CAA-Quebec: Jump-starting a car battery: Follow the guide! (Updated on December 17, 2025 (shown on page))